3/4 HP Sewage/Effluent Pump, 6400 GPH Submersible Basement Sewer Pump with 2'' Check Valve Connector

3/4 HP Sewage/Effluent Pump, 6400 GPH Submersible Basement Sewer Pump with 2'' Check Valve Connector

$251.99
Skip to product information
3/4 HP Sewage/Effluent Pump, 6400 GPH Submersible Basement Sewer Pump with 2'' Check Valve Connector

3/4 HP Sewage/Effluent Pump, 6400 GPH Submersible Basement Sewer Pump with 2'' Check Valve Connector

$251.99

About This

  • 【Excellent Performance】3/4 HP submersible sewage pump with high-efficiency oil-filled split capacitor motor has higher performance and greater reliability. Max Head: 29ft; 6400 GPH rating tackles any draining job in no time. Ideal for situations where deep pumping is required, such as basement drainage. Superpower helps you clean up all kinds of sewage efficiently.
  • 【Automatic and Manual Control】Automatic and manual functions are equipped with their own plugs in our sewer ejector pump. Use the automatic plug: If the water is enough, the switch floats and operates normally. If the water level is too low, the switch droops and the pump automatically off. Use the manual plug: The float switch has no effect, the pump is always on. If the water level is too low, you should unplug the plug manually.
  • 【Durable and Safe】The mechanical seal has good wear resistance and is made of silicon carbide under the protection of cast iron material shells. Built-in automatic thermal overload protector, overheating or dry boiling will automatically shut off. The non-clogging vortex impeller can pass through 2" NPT debris to keep the pump running continuously. Our pump has an IP68 waterproof rating and has obtained UL certification, so there is no need to worry about quality problems.
  • 【2'' NPT Check Valve】2'' NPT drain, fits all base and submersible sump pumps with 2" drain tube. Equipped with check valve. This connector does a great job of preventing water from backing up into the sump pump.
  • 【Quick Installation】The product can be easily installed without clamps. All you need to do is first attach the quick connector to the pump, then insert the PVC pipe into the connector, and finally tighten the nut.

You may also like